Help us out: Engine Designer Revamp

[noisymime]

But the two other, ign. timing and mixture, would really just need a name and range for the variable, like degrees [30,-10] and fuel/air ratio [x,y].

Ignition could possibly be converted to a 'Max advance' setting, but fuel/air ratio is next to impossible unless you can provide a full load map, which is going to be too complex for most people.

If you just specify a single a/f ratio, is that the one that's meant to apply to hard acceleration, highway cruising, idle? What about when on boost vs off boost? WOT vs half throttle? The concept of giving an abstract 'general mixture' figure isn't perfect, but it gets across the intent OK without the need to provide a full map.

[Daffyflyer]

It'll be changing to a "power" and a "cruise" mixture setting in future, but still not too complex

[stephenl9000]

If you look at the "Cold Steel Taxi" video you will notice that the flywheel on the Extra Large V8 goes through the dynamometer power measuring thing. This is an issue that should be adressed.

[Killrob]

Yes, this is a known issue which will be addressed thanks for pointing it out!

[Daffyflyer]

Should be fixed in the current patch in fact, yay!

[jimmyj]

if u have still loking for this designation then me available ?? but how i contact you