automationgame.com

Posted: **Sun Aug 04, 2013 11:27 pm**

I was originally aiming for a 318ti, but couldn't get the back short enough without a hacked .lua, which just meant I couldn't save (and wheres the fun there?)
I'm definitely proud of the front, and liberal vent abuse for washer jets, door handle and side trim
+ The automation logo makes a perfect boot button/ key hole when really small

The back leaves a lot to be desired but I couldn't really get sharp enough angles there

Details below each picture
part 1/3

: No square foglights : ( had to just go open vents instead; Car -1.png (426.23 KiB) Viewed 3006 times

: Liberal vent abuse side trim; Car -2.png (598.59 KiB) Viewed 3006 times

: Car -3.png (186.46 KiB) Viewed 3006 times

Posted: **Sun Aug 04, 2013 11:32 pm**

Part 2/3
details below each picture

: Backs a bit long but this was as short as I could make it; Car -4.png (362.66 KiB) Viewed 3005 times

: Tried to use a piece of bumper to get a sharper edge on the boot, but could only have it at this or 90 degrees so I settled with this; Car -5.png (416.77 KiB) Viewed 3005 times

: Washer jet with vents; Car -6.png (503.65 KiB) Viewed 3005 times

Posted: **Sun Aug 04, 2013 11:39 pm**

part 3/3, power

Its a 1998 model powered by a 1.9L m44 engine, which I specced as close as possible to the real engine

: 1998 m44.png (1.51 MiB) Viewed 3002 times

Posted: **Mon Aug 05, 2013 1:01 am**

Nice job!

automationgame.com

318ti / 318is crossover

318ti / 318is crossover

Re: 318ti / 318is crossover

Re: 318ti / 318is crossover

Re: 318ti / 318is crossover