318ti / 318is crossover

[wil7303]

I was originally aiming for a 318ti, but couldn't get the back short enough without a hacked .lua, which just meant I couldn't save (and wheres the fun there?)
I'm definitely proud of the front, and liberal vent abuse for washer jets, door handle and side trim
+ The automation logo makes a perfect boot button/ key hole when really small

The back leaves a lot to be desired but I couldn't really get sharp enough angles there

Details below each picture
part 1/3

No square foglights : ( had to just go open vents instead

Car -1.png (426.23 KiB) Viewed 3004 times

Liberal vent abuse side trim

Car -2.png (598.59 KiB) Viewed 3004 times

Car -3.png (186.46 KiB) Viewed 3004 times

[wil7303]

Part 2/3
details below each picture

Backs a bit long but this was as short as I could make it

Car -4.png (362.66 KiB) Viewed 3003 times

Tried to use a piece of bumper to get a sharper edge on the boot, but could only have it at this or 90 degrees so I settled with this

Car -5.png (416.77 KiB) Viewed 3003 times

Washer jet with vents

Car -6.png (503.65 KiB) Viewed 3003 times

[wil7303]

part 3/3, power

Its a 1998 model powered by a 1.9L m44 engine, which I specced as close as possible to the real engine

1998 m44.png (1.51 MiB) Viewed 3000 times

[Daffyflyer]

Nice job!