automationgame.com

Posted: **Mon Jun 24, 2013 8:47 am**

I've gone through and created my first engine based off of a real one. This is modeled after the 4G63 in the 2nd gen Eclipses 96-99. It's almost identical in power, 210 HP, 210 ft/lbs TQ (real ones have 214) with a 7K redline. I tried modeling the turbo specs correctly, but could be all wrong with those

Posted: **Tue Jun 25, 2013 12:55 am**

You might want to reduce the stroke and increase the bore... your bottom end (like it says on the picture) is reducing MTBF, you can easily reach 65,000km MTBF (or 40,000 miles MTBF) if you do so. Also you have a very low octane so increase the compression. Other than that, it is a good version of the 2nd gen Eclipses

Posted: **Tue Jun 25, 2013 7:20 am**

09webbad wrote:You might want to reduce the stroke and increase the bore... your bottom end (like it says on the picture) is reducing MTBF, you can easily reach 65,000km MTBF (or 40,000 miles MTBF) if you do so. Also you have a very low octane so increase the compression. Other than that, it is a good version of the 2nd gen Eclipses

You have to use the factory bore x stroke or it would not be said engine

Posted: **Tue Jun 25, 2013 7:35 am**

hmm, good point 8-)

Posted: **Tue Jun 25, 2013 11:20 am**

Remember, 2nd gen, 7 bolt main....crankwalk. They are already ticking time bombs! This game is accurate! :lol:

but for those who don't know what crankwalk is: https://www.youtube.com/watch?v=wFGGeIw5dwA

Posted: **Wed Jun 26, 2013 4:41 am**

Have you tried modifying your ignition timing up for the extra 4 hp ? or up something just one, seems like that would do it

good job anyway

automationgame.com

Mitsubishi 4G63

Mitsubishi 4G63

Re: Mitsubishi 4G63

Re: Mitsubishi 4G63

Re: Mitsubishi 4G63

Re: Mitsubishi 4G63

Re: Mitsubishi 4G63