2013 Focus ST

Please Ignore the Honda was my last car
Read further down for Focus ST
Here are a few pics of Her in evolution order~









Sadly, this is not pictures of every thing i have done to Her so far. I have a Pacesetter 4-2-1 Header sitting in my bedroom right now, it'll be till April Redoing all when i can go and get the rest of my Exhaust done. I am redoing all of it, since its nearly about to fall off in some spots.
Here are picturs of the RBB intake manifold off a 2005 Acura TSX K24A2 This intake was one HECK of an upgrade even though its still a factory intake manifold off a stock car.


Full info about my Honda~
Engine~
-RBB intake Manifold
-Weapon-R SRI system
-NGK Iridium-R Spark Plugs (The performance ones, cost like $18 a plug),
-125 Amp Alternator
-New Coil packs
Interior & Sound~
-Metra Turbo dash Kit
-Kenwood Excleon CD Player
-Under-dash LED's
-MTX 1200Watt Jack hammer AMP
-Dual MTX Jack Hammer 12" Sub's 4O 600 Watts Peak
-Atrend Ported box (not one in pictures, that is the old MTX box I busted)
- a cheap-o driver side seat cover, so my seats don't get dirty when i get off work
Future Mods~
-Full Length Exhaust (Heads, cat-to-Back. Debating on the muffler i wanna use)
-74mm or 80mm Throttle body
-Front Strut bar
-Shocks and Springs
-Brakes (real soon, almost have no rear brakes and front are starting to get rough)
-Lip kit or Body kit
-Carbon Fiber hood
-AND LAst but not LEAST, Remove the freaking dents off the passenger door.
Hope you like it, and any feed back Good or bad i like.
Thanks
Read further down for Focus ST
Here are a few pics of Her in evolution order~









Sadly, this is not pictures of every thing i have done to Her so far. I have a Pacesetter 4-2-1 Header sitting in my bedroom right now, it'll be till April Redoing all when i can go and get the rest of my Exhaust done. I am redoing all of it, since its nearly about to fall off in some spots.
Here are picturs of the RBB intake manifold off a 2005 Acura TSX K24A2 This intake was one HECK of an upgrade even though its still a factory intake manifold off a stock car.


Full info about my Honda~
Engine~
-RBB intake Manifold
-Weapon-R SRI system
-NGK Iridium-R Spark Plugs (The performance ones, cost like $18 a plug),
-125 Amp Alternator
-New Coil packs
Interior & Sound~
-Metra Turbo dash Kit
-Kenwood Excleon CD Player
-Under-dash LED's
-MTX 1200Watt Jack hammer AMP
-Dual MTX Jack Hammer 12" Sub's 4O 600 Watts Peak
-Atrend Ported box (not one in pictures, that is the old MTX box I busted)
- a cheap-o driver side seat cover, so my seats don't get dirty when i get off work
Future Mods~
-Full Length Exhaust (Heads, cat-to-Back. Debating on the muffler i wanna use)
-74mm or 80mm Throttle body
-Front Strut bar
-Shocks and Springs
-Brakes (real soon, almost have no rear brakes and front are starting to get rough)
-Lip kit or Body kit
-Carbon Fiber hood
-AND LAst but not LEAST, Remove the freaking dents off the passenger door.

Hope you like it, and any feed back Good or bad i like.
Thanks