automationgame.com

I cant perform a model test. Nothing happens and I cant save my model

The devs are working on it. Till the next update you might want to revert to b1354,, testing and saving should work in that version.

I was using the 1354 and then I up to 1355 thinking it was fixed but is not =(

Then try 1356

cant run yet

here is the platform

how does your computer rate on this chart? It seems like the test calcuations are pretty hard on lower spec computers since b1353.

Comparing my computer using this chart it is right in the middle. All green.
Core 2 Duo 2,8 Ghz
Radeon HD 6800 Serie
3,50 Gb Ram

Bullets, your platform is working for me. I know it doesn't help, it's just information...

I built a pretty much random model and it needed 1-2 seconds for testing.

Bayer, I once let it testing and went to dinner. 15 min later I back and nothing

I get this too, every now and again the game will just not process stats, I can close the model and open one that worked previously and then that too will not process them. If I close and reopen the whole game then it's fine for a while.
I wonder if there is some thread not being closed off and holding up the game.

We think we found the underlying issue now. The problem was connected to framerates below 20, as strange as that sounds.

Bizarre, well it fits with my pc, nice fast i7 processor but no not so strong mobile gpu (gt 450m)

I tried the 1357 right now and it is not working yet.
It runs on 40 fps. When I click to test it falls to 5 and goes to 40 again but nothing happens. The test cant finish =/

Installed 1358 and didnt work =/