Page 1 of 1

Axle graphic problem

PostPosted: Thu Jan 16, 2014 4:14 am
by Bullets
I was testing the new feature pressing + and - to test the suspension and I found this problem when I was creating a new model.
And it seems that the inside piece is not synched while it moves. While it moves you can see it passing throuhg the outside piece.
I dont know if you already know but here it is:

Re: Axle graphic problem

PostPosted: Thu Jan 16, 2014 9:44 pm
by zeussy
Thanks for the report. It looks like it is loading unneeded prop shafts.