automationgame.com

When I save an engine as a new revision, or overwrite an engine with a new tune, it does not save when I close and re-select the engine.

So you make a revision, save it, and then close the designer. Then you re-open it and it's still the old version?
Does that happen also when you leave the Engine Manager and go back to the main menu before?

It doesn't happen all the time, but sometimes if i save a new revision, the parts I changed will save, but the tune is still of the last version. Other times it will fail to load the revised version even though I selected it and load the original unmodified engine.

The other problem is if I change a tune of a certain engine and overwrite the save, it is most often the Cam Profile that does not save. I think I've found that saving several times can prevent this, other times I have to delete the savefile for the engine and save a fresh one.

Thanks for the description! We'll have a look into that.
Are there particular sliders that will be set differently? Like ignition timing, etc.?