Can't Zoom out enough?

[Didge3]

So I've had the game a long time now and I still love it, eagerly await the next update

But I feel like when I create a finished engine, no matter the size of it V8, l4, large or small capacity, I can't zoom out as much as I used to, maybe I'm just imagining it but I feel like I can barely fit the entire engine in the display?

[maffc]

Perhaps your resolution settings are set low

[Didge3]

Perhaps your resolution settings are set low

The game is set to my maximum resolution (1440x900) and quality settings are maxed.
I'll get a screenshot of what I mean next time I play to see if its normal...

[Daffyflyer]

Yup, post a screenshot, I've not seen this problem before.

[Didge3]

So after realizing that I can't get a screenshot in fullscreen I went into windowed mode and got one.
Being in windowed mode helps a little, the engine is easier to fit onto the display although with the UI overlay I still feel I could do with the 'camera' being a bit further from the engine.
He's my 785cc twin turbo V8. So its quite small but it literally fills the screen. The issue is slightly worse in fullscreen, I opened the same engine to the same angle and the intercooler is completely out of the view area air filter is closer.

Automation.png (1.6 MiB) Viewed 4435 times

I assume this might not be an 'issue' but rather how the game is intended, I just feel like given the ability to zoom in there should be more zoom out available?

[Daffyflyer]

Something is not right there, here is a 700cc v8 at max zoom out on my Automation.

I'm assuming you're zooming using the mousewheel?

[Jakgoe]

Or just press the + and - buttons on the keyboard.

[Didge3]

Yes I have been zooming using the mouse wheel. I'll try the + and - buttons later, thanks

[VicVictory]

Sorry to threadjack, but that exhaust is comically large compared to the engine.

[Killrob]

Sorry to threadjack, but that exhaust is comically large compared to the engine.

Andrew likes his 6" pipe