Page 1 of 1
Bore & Stroke
Posted:
Sat Sep 01, 2012 6:06 amby Unreal2004
I believe the bore and stroke limit should be increased, there were several mass produced 4 cylinder(at minimum over 1 million) and inline 6 engines that had a 4.375"(111.1mm) stroke which cannot be reproduced in Automation at this time, most is 3.937"(100mm), there is at least one motorcycle with a 4.4"(112mm) bore also but was a difficult example to find.
Re: Bore & Stroke
Posted:
Sat Sep 01, 2012 6:38 amby Kubboz
Revamp coming in late september (or october) will have these limits increased.
Re: Bore & Stroke
Posted:
Sat Sep 01, 2012 9:30 amby Unreal2004
Re: Bore & Stroke
Posted:
Sat Sep 01, 2012 6:31 pmby Killrob
The new limits for all engines will be 120/120 mm
Re: Bore & Stroke
Posted:
Sat Sep 01, 2012 6:50 pmby Unreal2004
Re: Bore & Stroke
Posted:
Sun Sep 02, 2012 11:09 amby pleo
i like to see fiat punto gt stroke there too (67.4 mm / 2.65 in)
80.5 × 67.4 mm
Re: Bore & Stroke
Posted:
Sun Sep 02, 2012 5:02 pmby Killrob
Yes, that bore/stroke setting won't be a problem in the revamp.
Re: Bore & Stroke
Posted:
Sun Sep 02, 2012 7:47 pmby pleo
nice
