Re: Necronn's 3D Stuff
still trying to improve it a bit.
Owner of company: Necronassassin
http://automationgame.com/phpBB3/viewtopic.php?f=35&t=4993
Established: 1994
Company ID: 1994777
Turbocharged
Posts: 2221
Joined: Sat Mar 23, 2013 8:39 am
Location: The Netherlands
Cars: Citroën Saxo, Mazda 2
Weasel wrote:I'm only confused a little bit about the black (plastic?) bar in the middle. It seems to be hoovering in front of the grillie and the sides seems to be cut off.
Naturally Aspirated
Posts: 1178
Joined: Wed Jul 04, 2012 4:29 am
Location: Spain
Cars: A undestructable Toyota with 1ZR FAE engine, Honda Civic VTi EG6, Mazda RX7 fc
vmo wrote:Good grille.
From what model is it?
Naturally Aspirated
Posts: 1178
Joined: Wed Jul 04, 2012 4:29 am
Location: Spain
Cars: A undestructable Toyota with 1ZR FAE engine, Honda Civic VTi EG6, Mazda RX7 fc
necronassassin wrote:here a preview image of my not mazda taiki grille;)
still trying to fixs some things
vmo wrote:Very good job!
necronassassin wrote:vmo wrote:Very good job!
thanks:) any idea how i can remove that ugly UV mesh line
Weasel wrote:necronassassin wrote:vmo wrote:Very good job!
thanks:) any idea how i can remove that ugly UV mesh line
Maybe, you can try to re-scale the UV, as long till there is no issue anymore
Naturally Aspirated
Posts: 1178
Joined: Wed Jul 04, 2012 4:29 am
Location: Spain
Cars: A undestructable Toyota with 1ZR FAE engine, Honda Civic VTi EG6, Mazda RX7 fc
necronassassin wrote:vmo wrote:Very good job!
thanks:) any idea how i can remove that ugly UV mesh line
vmo wrote:necronassassin wrote:vmo wrote:Very good job!
thanks:) any idea how i can remove that ugly UV mesh line
Yes.
First, you need to select all vertex near the X=0 axis.
Once you make this, you need to unmerge the UVMesh, and you need to reduce a little the UVMesh with the scale (and make the same with the vertex near x=0 of the rear step), and erase these polys with the redo keyboard key (the same to erase words key), EXCEPT THE TWO CORNERS (not erase the unselected vertex in the image).
And you need to align the UVMesh with the grille perfectly with the help of align tool (first select the UVMesh, and secondly, any vertex of the grille, and "play" with the align position (world).
Return to 3d Artists Modding Forum
Users browsing this forum: No registered users and 0 guests