new builder need help

[n9mfk]

Hi All,
Im new at this im try to build Pentastar engine 3.6 with vvt
I can no get the bore an stroke to match
Chrysler Powertech V6
Configuration 60° V6
Displacement 3,604 cc (219.9 cu in)
Cylinder bore 96 mm (3.8 in)
Piston stroke 83 mm (3.3 in)
Cylinder block alloy Aluminum
Cylinder head alloy Aluminum
Valvetrain Dual overhead camshaft
Compression ratio 10.2:1
Fuel system Sequential Multiple-Port Fuel Injection
Fuel type Gasoline
E85
Oil system Wet sump
Cooling system water-cooled
Length 503 mm (19.8 in)

thanks for any help Beau

[Juno8]

put that information into the game and you should be able to work it its that easy...

[Juno8]

I will build it for you but its gonna be an I6 not a V6

[Juno8]

Here is your engine and it took me less than 10 minutes to built following your crude instructions and I took a few assumptions on what parts and stuff but I got a good 250bhp out of it

[n9mfk]

Thanks it look like mm are closer then in thanks for the help

[Juno8]

when building engines go metric imperial is a pain in the ass to get right and just get practising I am already building racing engines from the 1960s but with parts from 2020 because well the guys back then were using Aluminium when the average joe was using Cast Iron...